TRIPPLITE SMX5000XLR 3U Rack

System overview: SmartPro line interactive 3U expandable rack /tower UPS Voltage compatibility: 230V nominal Frequency compatibility: 50/60Hz (Auto-sensing) OUTPUT Output volt amp capacity (VA): 5000 Output watt capacity (watts): 3750 Output nominal voltage: 230V Output voltage regulation: LINE MODE: Sine wave line voltage 230V (+8% / -17%), BATTERY MODE: Sine wave 230V (+/-5%) Output frequency regulation: LINE MODE: Passes line frequency of 50/60Hz +/-10%, BATTERY MODE: Inverter output regulated to 50/60Hz (+/-0.5Hz) Outlet quantity / type: 11 outlets total (3 C19, 8 C13) Overload protection: Via 3 built-in 15A output circuit breakers INPUT Maximum input amps: 27A Input connection type: Hardwire BATTERY Full load runtime: 10 minutes (5000VA), 37 min with 1 BP48V60RT3U battery pack Half load runtime: 27 minutes (2500VA), 78 min with 1 BP48V60RT3U battery pack Expandable battery runtime: Yes, runtime is expandable with optional BP48V60RT3U external battery packs DC system voltage: 48VDC Typical battery lifespan: 3-6 years, depending on usage Battery recharge rate: 2-4 hours to 90% VOLTAGE REGULATION Voltage regulation description: Automatic Voltage Regulation (AVR) circuits maintains clean, regulated computer-grade 230V nominal output, without using battery power, during brownouts to 170V and overvoltages to 282V Overvoltage correction: Input voltages between 245 and 282 are reduced by 12% Direct pass through: Input voltages between 200 and 244 are passed through to connected equipment unchanged Brownout correction: Input voltages between 170 and 199 are boosted by 12% LEDS ALARMS & SWITCHES Front panel LEDs: 5 front panel LEDs - Green POWER LED, Green VOLTAGE CORRECTION LED, 3 color BATTERY CHARGE LED, 3 color OUTPUT LOAD LED, red BATTERY WARNING LED Alarms: 3 function audible alarm indicates power failure conditions (4 short beeps every 10 seconds), overload (continuous short beeps) and low battery (continuous tone) Switches: Yes, includes 2 front panel mounted push button switches for system enable, self-test and alarm cancel functions SURGE / NOISE SUPPRESSION AC surge suppression: 1800 joules AC suppression response time: Instantaneous EMI / RFI AC noise suppression: Yes PHYSICAL Shipping weight (lbs): 163.6 Shipping weight (kg): 74.3 Unit weight (lbs): 135.6 Unit weight (kg): 61.6 Unit Dimensions (HWD/in): 5.25 x 17.5 x 22.5 Unit Dimensions (HWD/cm): 13.3 x 44.5 x 57.2 Shipping Dimensions (HWD/in): 11.5 x 23.5 x 29.5 Shipping Dimensions (HWD/cm): 29.2 x 59.7 x 74.9 Material of construction: Steel Form factors supported: Ships with all accessories required for 3U rackmount installation in a 4 post rack enclosure, 2 post rackmount is supported with optional 2POSTRMKIT, supports tower installation with optional 2-9USTAND Cooling method: Set of 2 built-in cooling fans Battery Access: Battery access door allows hot swap battery replacement without powering connected equipment off ENVIRONMENTAL Operating Temperature: +32 to +104 degrees Fahrenheit Storage Temperature: +5 to +122 degrees Fahrenheit Relative Humidity: 0 to 95%, non-condensing COMMUNICATIONS Network monitoring port: Includes built-in USB and DB9 serial ports, Each supports on battery, low battery, power restored, AC line voltage, DC battery voltage, load percentage, battery charge current, battery capacity, internal UPS temperature and line frequency status messaging. Interface supports timed inverter shutoff after unattended shutdown, activate self-test and 10 second reboot of connected equipment. Supports reboot of all connected devices at once via software interface. DB9 port also supports standard UPS contact closure messaging. Compatible with Tripp Lite's PowerAlert software. Software and cabling included: Includes PowerAlert UPS monitoring software for all common network and standalone operating systems. Ships with USB and DB9 serial cables SNMP compatibility: Built-in accessory slot accommodates internal SNMP / Web card and other network accessories WatchDog compatibility: Yes, compatible with Tripp Lite's Watchdog system service to restore operation to locked equipment through soft reboot of applications / OS or hard power off/on reboot of connected equipment - ideal for unattended kiosk applications LINE / BATTERY TRANSFER Transfer time from line power to battery mode: 2-4 milliseconds Low voltage transfer to battery power: 170VAC (resets to line power as voltage increases to 179VAC) High voltage transfer to battery power: 282V (resets to line power as voltage decreases to 274VAC) CERTIFICATIONS Certifications: CE, GOST, SASO WARRANTY Product warranty: 2 year product warranty SPECIAL FEATURES EPO port: Includes RJ11 EPO (emergency power off) port and interconnection cable TVSS grounding: Includes back panel grounding point with thubscrew for data line surge suppressors and other network accessories req